Symbol Scanner Cable For Verifone Ruby 2, CI, C18, Topaz XL on COM8 RJ50 to RJ45

This is a part # CBA- R28 -C09ZAR scanner cable used ONLY to connect compatible Symbol, Zebra, or Motorola bar code scanners (as listed below) to a compatible. Verifone POS register, like the Ruby2, RubyCI, C18 and Topaz XL. Does not fit D a t a l o g i c. See our alternative Verifone compatible scanner cable listing. Does not fit H o n e y w e l l / O r b i t. Compatible cables for this brand are discontinued. The only way this cable would work is if you replace your existing scanner with a compatible scanner by Symbol, Zebra or Motorola. ONLY fits Symbol / Zebra / Motorola brand scanners with part numbers.

(an older, discontinued, but compatible part #). If you don't have a Symbol, Zebra, or Motorola branded barcode scanner, or have a cable with an unlisted part number, then this is not the correct cable.

This cable is 56 inches when coiled and stretches to up to 9 feet (2.8 meters) long when uncoiled. It has a 10-pin RJ50 (RS-232 serial) male end that goes to the Symbol scanner and the other RJ45 8-pin male connector, which looks similar to an ethernet end, goes to a serial COM port on the back of the Verifone terminal. Typically this RJ45 end goes to the COM8 port. We'll typically respond within hours, if not minutes. This item will be loose packed with no consumer packaging or instructions included. This is not an exhaustive list, but these and other Symbol / Zebra scanner and cradle models with the common 10-pin (square head) male end may work when connected to a compatible Verifone Ruby terminal with the correct emulation mode. LS4278 via the STB4278 Cradle. MT2090 via the STB2078 cradle. DOES NOT fit D a t a l o g i c scanners and should NOT be used with unlisted point of sales systems or scanners. Review our alternative Verifone compatible scanner cable listing if your scanner has this other brand.